Cleanup and Reset Network Adapters in Command Prompt
1. Open an elevated command prompt.
2. Type the command below in the elevated command prompt, and press Enter.
If you run the command and receive an error referring to NetSetupDeleteObject, run the netcfg –d command until it’s successful.
netcfg -d
3. When finished, restart the computer to apply.
2. Type the command below in the elevated command prompt, and press Enter.
If you run the command and receive an error referring to NetSetupDeleteObject, run the netcfg –d command until it’s successful.
netcfg -d
3. When finished, restart the computer to apply.
Comments
Post a Comment